[Elecraft] PX3 case for P3?

[Bruce Beford]

Yes, I have seen the user-modified P3 units. I am still hoping Elecraft will
offer a set of panels to repackage the P3 into a shallow case, similar to
the PX3.

73

Bruce N1RX

 

  _____  

From: Jeff Stai [mailto:wk6i.jeff at gmail.com] 
Sent: Saturday, April 05, 2014 8:05 PM
To: Bruce Beford
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] PX3 case for P3?

 

Hi Bruce. I was looking at the PX3 case today. It's not very deep and the
current P3 won't fit in there. And Eric did confirm that. 

 

Some people have cut the stock P3 sides, top and bottom shorter to achieve a
similar profile. 

 

73 jeff wk6i

On Saturday, April 5, 2014, Bruce Beford <bruce.beford at myfairpoint.net>
wrote:

Please consider the possibility of offering an enclosure option for the P3.
In many cases, it would be nice to have the P3 in a case footprint similar
to the PX3. Perhaps with the sheet metal design work already done for the
PX3, this would not be cost prohibitive. Possible?

73,

Bruce

N1RX

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net <javascript:;> 

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to wk6i.jeff at gmail.com <javascript:;> 



-- 
Jeff Stai ~ wk6i.jeff at gmail.com
Twisted Oak Winery ~ http://www.twistedoak.com/
Facebook ~ http://www.facebook.com/twistedoak