[Elecraft] [KX3] PX3 Questions

Wayne Burdick n6kr at elecraft.com
Fri Apr 4 20:07:11 EDT 2014


Dimensions identical to KX3 case except 2" (5 cm) narrower. Fits in your pocket, should the need arise. Includes KX3-style fold-up tilt feet.

Wayne

----
http://www.elecraft.com

> On Apr 4, 2014, at 4:52 PM, Edouard Lafargue <edouard at lafargue.name> wrote:
> 
> Speaking about the case: will it be the same depth as the kx3 or slimmer? As slim as possible would make sense to fit it into a travel case...
> 
> Ed W6ELA
> 
>> On Apr 4, 2014 5:33 PM, "Phil Wheeler" <w7ox at socal.rr.com> wrote:
>>  
>> Case: Good point. I have several kit I build that look ugly because I did the case poorly.
>> 
>> Phil W7OX
>> 
>>> On 4/4/14, 4:13 PM, Edouard Lafargue wrote:
>>>  
>>> 
>>> Nice one! Not easy to get that low power and very wide bw on a homebrew project! And I'm not speaking about the casing which IA often a nightmare on homebrew...
>>> 
>>> Ed W6ELA
>>> 
>>>> On Apr 4, 2014 4:27 PM, "Wayne Burdick" <n6kr at elecraft.com> wrote:
>>>>  
>>>> "Michael A. Waldron" wrote:
>>>> 
>>>> > So, having had time to digest the datasheet, I have a few questions and I'm sure I'm not alone.
>>>> > 
>>>> > Resolution of screen? 200khz is great, but if I can only see 200px it's somewhat less fantastic.
>>>> 
>>>> 480 x 272. It's the same LCD we use on the P3.
>>>> 
>>>> > Power Source? 
>>>> 
>>>> 8-15 VDC. Current drain typically 140 mA at 13.8 V. Possible internal battery pack -- plenty of room, though we may or may not offer one.
>>>> 
>>>> > I'm sure you guys have worked this out, but I noted no mention of compatibility with the KXPA100?
>>>> 
>>>> 100%.
>>>> 
>>>> > You guys didn't happen to include a decent speaker in there did you? :)
>>>> 
>>>> Only if a PCB vibrates.
>>>> 
>>>> > Looking forward to playing with it!
>>>> 
>>>> If you want to know what it does beforehand, take at look at the P3 manual. Functional overlap will be better than 90%. 
>>>> 
>>>> Note: The PX3 requires baseband I/Q signals (available at the KX3's RX I/Q jack); it can't be used with the K3's 8.2-MHz I.F. output. 
>>>> 
>>>> 73,
>>>> Wayne
>>>> N6KR
>> 
> 
> __._,_.___
> Reply via web post	 Reply to sender	 Reply to group	Start a New Topic	Messages in this topic (7)
> VISIT YOUR GROUP New Members 27 New Photos 20
> • Privacy • Unsubscribe • Terms of Use 
> .
>  
> __,_._,___


More information about the Elecraft mailing list