[Elecraft] P3 No Longer Matching K3 Signal Level

[Alan Bloom]

There's an explanation of the reasons for this in the P3 Owner's Manual 
in the "How to set up and Interpret the P3 Display" section.  Start 
reading where it says, "You would expect the S meter on the K3 and the 
signal on the P3 display to indicate the same level..."

Alan N1AL


On 04/01/2014 10:54 AM, Bud Governale wrote:
> My P3 always matched S meter signal level to the K3.
>
> This morning with the S0 on the K3 ( with antenna disconnected) the P3 is
> displaying a level about 7 db below the S0 level.
>
> With antenna connected the K3 shows S7 while the P3 level on the screen is
> slightly below S0.
>
> What happened and how do I fix this?
>
> 73,
>
> Bud W3LL
> w3ll at arrl.net
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>
>