[Elecraft] FW: RE: K2 Mic Configuration

[Gary W. Hvizdak]

On Sun Sep 29 2013 at 12:06:52 EDT Steve wrote ...

"K2 mic configuration.  I use computer jumpers for the mic headers ..."

--- - - - ---

Steve,

    If you are going to be experimenting, then I suggest the Rework
Eliminator(TM) K2 Internal Mic Adaptor (IMA).  It supports jumper
configurable wiring of the pin-out as well as seven jumper selectable bias
resistances between 820 and 10k Ohms.  All Alinco, Elecraft, Heil, Icom,
Kenwood, Ten-Tec, and Yaesu 8-pin Foster microphone pin-outs are supported.
And best of all, you don't have to disassemble the radio to change
configurations!  All that's required is removal of the left side panel!

    See http://www.unpcbs.com/#rework_eliminator_TM_products for a brief
description, or visit http://www.unpcbs.com/adaptor/ for full details.

73,
Gary  KI4GGX
(webmaster)