[Elecraft] KBPF3 and KPA500

[Jim Leder (Hotmail)]

 I installed a KBPF3 option, and it works OK, mostly. I also have a PR6, so I am trying to use the BYPASS connector of the PR6. I have pulled the jumper in the PR6, so the BYPASS would would work. And it does, as long as my KPA500 cable is disconnected. When I connect the KPA500 control cable, it seems power is ALWAYS applied to the PR6, rendering the BYPASS not connected. DIGIOUT1 is off on all bands, except 6. When I disconnect the KPA500 control cable, all works as it should (except the KPA500). What am I missing?


     Jim Bob Buckeye 
            AKA
  **** Jim Leder****
    K8CXM since 1961
 IBM retiree since 1999
  
There are 10 types of people in this world -- those who understand binary
and those who don't.