[Elecraft] k2 ssb

[Don Wilhelm]

Royce,

Remove the left side panel, and you should see a 5.6k resistor soldered 
between pin 6 and pin 1 of the microphone jack.  Lift the resistor from 
pin 1 and an non-amplified Kenwood microphone should work just fine.

If it is an amplified mic, you will have to remove the front panel and 
chenge the microphone configuration header to route +5 volts to pin 5 
instead of pin 6.

73,
Don W3FPR

On 9/11/2013 8:09 PM, ROYCE RAINWATER wrote:
> I have purchased a used k2 which has the ksb2 ssb adapter installed and was
> used with the elecraft hm 2 which I did not get.  I have a kenwood hand
> mike that came with the kenwood ts590 and am looking for advise configuring
> the k2 for the kenwood hand mike.
>
>