[Elecraft] [600MRG] Use of K3 on 600m (and below)
Fred Jensen
k6dgw at foothill.net
Wed Sep 11 12:23:33 EDT 2013
Help me out here ... if I go into TEST mode and send something, my K3 is
really making RF, albeit not much?
As I accumulate birthdays, I find that, while my copy skill stays fairly
constant, my "fine motor skills" are declining, and I don't get enough
sending practice on the air. I've been getting the exercise in TEST
mode, sometimes with the KPA500 in OPERATE and an antenna connected on
the belief that the manual was correct and I wasn't making any RF. So
far, I don't think I've sent any state secrets, credit card numbers, or
other private information ... maybe I should put the dummy load on?
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 2013 Cal QSO Party 5-6 Oct 2013
- www.cqp.org
On 9/11/2013 12:37 AM, Edward R Cole wrote:
> Yes, the lowest transverter IF is 7-MHz. Of course you can operate the
> K3 in low power transceive on any frequency from 490-KHz to 32-MHz if in
> the TEST mode.
More information about the Elecraft
mailing list