[Elecraft] k3 sdr-ir pan adapter

[Wes (N7WS)]

When you ask to be contacted off-list about a question posted to the list, no 
one knows whether you got an answer or not.

So here's my answer: You need to download and install LP-Bridge. 
http://www.telepostinc.com/LPB.html

Create a virtual port in LP-Bridge and configure SDR-IQ/SpectraVue by selecting 
the K3 In the ExtRadio tab and the virtual port that you created in LP-Bridge.  
Make sure the baud rates match and check, the Keep Same Center Freq box.

You can create other virtual ports that connect to logging programs, etc that 
need freq/band data from the K3.

Wes

On 8/31/2013 4:04 PM, l s wrote:
> Just acquired a rf space sdr- iq receiver and I would like to contact someone using the same set up.
>
> I managed to make it work as a stand alone receiver with Spectravue and sdr-radio.com v 1.5 but
> I can't get either of the software programs to control the K3. I have checked the rs 232 cable and the pin out is correct.
> This cable works fine with lp pan and powersdr-if. Any help would be appreciated. Please contact me off the reflector
> at- lgs42450 at yahoo.com
>
> Tnx & 73
>
> Lou KI6UM