[Elecraft] K2 Linearize VCO question

[Don Wilhelm]

Ed,

Those early instructions were changed with firmware MCU release 2.00 and 
above.
Hold any button down while you power on and the K3 will display the 
firmware version briefly.  If it shows MCU 2.00 or above, run CAL PLL 
only on 40 meters.
Below that version, run it on each band.

73,
Don W3FPR

On 9/2/2013 12:06 AM, Eddy wrote:
> I notice in early documentation on the Elecraft website they mention running CAL PLL on each band, but in my K2 manual (Serial # 3600+) it only talks about running CAL PLL between 7000 and 7100, the 40-mtr band.
>
> Can someone tell me the official recommendation on CAL PLL?
>
> Thanks much!
>
> 73, ed
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>