[Elecraft] K3 Current Drain When Off

Wayne Burdick n6kr at elecraft.com
Wed Oct 16 16:33:43 EDT 2013


Jim,

Here's one possible explanation:

The external power supply must drop all the way to zero V, as must any all K3 I/O signals. This may have implications for attached equipment.

If there's any residual voltage on the supply or I/O lines, even 1 V, the K3 may not turn off all the way. It turns out that the brown-out detection circuitry on microcontrollers can be confused at some power levels that are low enough to look like a brownout but not high enough to properly power the detection circuitry. Under such conditions the MCU may continue to run on power-down via the on/off switch, resulting in the radio drawing an unpredictable amount of current.

If residual supply or I/O leakage isn't the cause, then I suspect a problem with your K3's on/off circuitry or possibly even the PA module. (You could test the latter theory by unplugging the KPA3.) Every K3 we've tested drops to a very small number of milliamps of current drain when off.

73,
Wayne
N6KR

 
Jim Brown <jim at audiosystemsgroup.com> wrote:

> Nope. I measured both units several times, and just now repeated the measurements.
> 
> 73, Jim
> 
> On 10/16/2013 11:23 AM, Eric Swartz - WA6HHQ, Elecraft wrote:
>> Hi Jim - you must be misreading the meter by several decimal points :-)
>> 
>> We just measured several K3s in the lab and they both draw less than 5 mA when off.
>> 
>> Eric
>> elecraft.com





More information about the Elecraft mailing list