[Elecraft] Using K3 to measure noise levels

[amsctalx at comcast.net]

November 2013 QST Technical Correspondence - "More Citizen Science", page 62. It isn't so much an article as it is a letter, and isn't explicitly mentioned in the table of contents. 


Mike Alexander - N8MSA 

amsctalx at comcast.net 

----- Original Message -----
From: "Rich - K1HTV" <k1htv at comcast.net> 
To: "David Cutter" <d.cutter at ntlworld.com> 
Cc: "Elecraft Reflector" <elecraft at mailman.qth.net> 
Sent: Tuesday, October 15, 2013 7:22:34 AM 
Subject: Re: [Elecraft] Using K3 to measure noise levels 

David, 
I checked the Sept., Oct. and Nov. issues of QST, looking for your article about long term calibrated recording of noise but couldn't find it. Also couldn't find any mention of 'Citizen Science'. Where can we find your article ? 

73, 
Rich - K1HTV 

= = = 

----- Original Message ----- 
From: "David Cutter" <d.cutter at ntlworld.com> 
To: "Sam Morgan" <k5oai.sam at gmail.com>, "Rich - K1HTV" <k1htv at comcast.net>, "Elecraft Reflector" <elecraft at mailman.qth.net> 
Sent: Tuesday, October 15, 2013 6:05:33 AM 
Subject: Re: [Elecraft] Using K3 to measure noise levels 

For anyone serious about long term calibrated recordings of noise, see my 
article under Citizen Science in the latest QST. 

73 

David 
G3UNA 

______________________________________________________________ 
Elecraft mailing list 
Home: http://mailman.qth.net/mailman/listinfo/elecraft 
Help: http://mailman.qth.net/mmfaq.htm 
Post: mailto:Elecraft at mailman.qth.net 

This list hosted by: http://www.qsl.net 
Please help support this email list: http://www.qsl.net/donate.html