[Elecraft] K3/0 tx audio problem

[Doug Joyce]

Paul:  Assuming that you are using the Elecraft cables - the mic audio and PTT from the front panel Mic connector of the K3/0 is hard wired to the Mic mono and PTT In on the rear panel of the K3/0.  The Elecraft cable then takes those signals to the AUX/MIC RJ-45 connector on the front panel of the Control RRC  (refer to Fig 10, pg 13, K3 Remote Users Manual.   Once the K3/0 and the K3/100 are talking any setting on the K3/100 is reflected on the K3/0 (don't make the mistake of thinking that the K3/0 can be set differently from the K3/100).  So you need to set the K3/0 Mic (which is really controlling the K3/100) to be rPL.  

Good Luck

Doug  VE3MV

 
On 2013-Oct-13, at 10:26 AM, "Paul A DeFelice" <k9nu at mchsi.com> wrote:

> Just received my K3/0 and in the process of setting it up. RX, dual RX and
> CW are working great. I can't get any audio on SSB. I have the remote
> (K3/100) MIC SEL set to rP.L and the local K3/0 MIC SET set to fP.L . The
> mic plugged into the front connector of the K3/0. PTT is working but no ALC
> defection. Any suggestions?
> 
> 
> 
> 73,
> 
> Paul K9NU
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>