[Elecraft] K2-TX and RX frequency not the same

[Don Wilhelm]

Mike,

If this is in CW, either you do not have the menu ST P (sidetone pitch) 
set to the frequency you prefer for listening, OR you need to re-align 
your IF filters (CAL FIL) so the BFOs are centered at the same frequency 
you have selected for your sidetone pitch.

If this condition is present in SSB, then the IF filters are the only 
answer.  For information on optimizing your K2 filters, you can refer to 
my website www.w3fpr.com - look at part 3 of the article on K2 Dial 
Calibration (or go through the entire procedure).

73,
Don W3FPR

On 10/7/2013 2:21 PM, VICKI wrote:
> Hello All,
> My K2 TX frequency is exactly and shown on the LCD, but in order to hear station replying I have to RIT down about 500 Hz. Why is this happening and how can I fix it?
>