[Elecraft] K2 cntrl brd res reading

[Don Wilhelm]

John,

That is just fine.  I know a range was specified, but you are only 6% 
out of that range and normally a 10% variation is acceptable.

In the case of those particular signals, they are connected only to the 
P3 connector at this time, so your ohmmeter is reading only the 
resistance displayed by U6 itself, and the actual reading is dependent 
on which particular ohmmeter is being used.

73,
Don W3FPR

On 11/25/2013 2:28 PM, wt5y wrote:
> K2 control board all resistance readings ok cept I get 95 k for U6 pins 29 30 which call for 70-90k.
>
> WT5Y
>
> Sent from my Cricket smartphone
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>