[Elecraft] K3- CW frequency offset adjustment

[Joe Subich, W4TV]

> I'll tune in a CW station with a tone that is pleasant to my ear and
> the K3 will read 28.049.920. But if I use CWT to tune the same signal
> then the K3 will read 28.049.960. Therefore, I'm about 40 cycles off
> his frequency.

Change your Pitch setting by 40 Hz ... the K3's pitch is currently
40 Hz higher than hat your "ear" prefers so if PITCH is 500 Hz (for
example) change it to 460.

73,

    ... Joe, W4TV


On 11/16/2013 10:02 AM, RLVZ at aol.com wrote:
> Hi Guys,
>
> I typically tune in CW stations .040hz lower than  typical.  Such as, I'll
> tune in a CW station with a tone that is  pleasant to my ear and the K3 will
> read 28.049.920.  But if I use CWT  to tune the same signal then the K3
> will read 28.049.960.   Therefore, I'm about 40 cycles off his frequency.
> That's usually not  a problem unless the other station is running a narrow
> filter.   In contest conditions this .040 offset often does make a  difference.
>
> I realize I could adjust the RIT or XIT for this 30 cycle  difference and I
> often do that, but that's a pain  because when clicking a Packet Spot or
> changing bands the RIT/XIT is often  reset to zero.  So I'm wondering if
> there's a MENU  setting on the K3 that would allow me to change the CW transmit
> frequency  permanently by this 30 cycles?
>
> Thanks!
>
> Dick- K9OM
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>