[Elecraft] Importance of good coaxial jumpers
Douglas Person
k0dxv at aol.com
Tue Nov 12 16:25:57 EST 2013
I use teflon insulated PL-259’s. I use a small propane torch to solder the holes. I get the connector hot enough for the solder to flow into holes resulting in a very smooth surface. This approuch has never failed. But, the teflon is critical.
Doug — K0DXV
On Nov 12, 2013, at 9:12 AM, AG0N-3055 <mcduffie at ag0n.net> wrote:
> On Tue, 12 Nov 2013 10:21:02 -0500, Charlie T, K3ICH wrote:
>
>> The big
>> Weller D550 guns (250/325 watt) are not temperature controlled but can make
>> heat a lot quicker.
>
> That's my weapon of choice too.
>
> Gary
> --
> http://ag0n.net
> 3055: http://ag0n.net/irlp/3055
> NodeOp Help Page: http://ag0n.net/irlp
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
More information about the Elecraft
mailing list