[Elecraft] Using Cal Fil on K2/100

[Tom Field]

I have been re-aligning my K2 after finishing the K2 100 options.  Dial
calibration and PLL have gone without problem. I'm able to set the LSB/USB
filters using Cal FIL.  When I'm trying to use CAL fil to set the CW
filters acct N0SS's notes, I can't move the pass band down so the filter is
set over the 600 hz line. the BFO "jumps" and then starts over again.  Any
Idea what the problem is?


Tom F.
KI6NRD
Elecraft K2/100 7432