[Elecraft] using the PR6

[William Hein]

I am slightly confused on the proper operation of the PR6.  I installed the PR6 on my K3 according to the instructions:

	** CTRL line used (supplied DB-15 connected to ACC port)

	** PR6  jumper P2 removed

	** CONFIG: DIGOUT1 ON set on 6m

So, when I am operating on 6m do I select RX ANT and PRE or just RX ANT?  If just RX ANT is the appropriate protocol what will be the effect will selecting both PRE and RX ANT?  I've fuddled about with these buttons but would like to know the recommended procedure.

73
Bill

William Hein, AA7XT
ex-AA4XT, NT1Y, AA6TT, KC6EDP