[Elecraft] Combo pre-amp

[Edward R Cole]

You are assuming the internal K3 preamp is adequate on 6m in the 
K3.  The reason for the PR6 is that the internal preamp is not 
adequate for very weak signals (I intend to do 6m eme and ms).  Of 
course if you mean the PR6 is installed internal to the K3 then I 
suppose it would work.

The current configuration is "bolt on" ready and no need for an 
internal installation of the PR6 (or my preamp).

73, Ed - KL7UW
------------------------------------------------------
Date: Mon, 27 May 2013 09:01:37 -0700
From: Vic K2VCO <k2vco.vic at gmail.com>
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Combo pre-amp
Message-ID: <51A38361.8090801 at gmail.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

You could simply run your coax from the relay after the amplifier 
directly to the rx-in
jack. Surely an internal preamp would be located between this jack 
and the rest of the
receiver. You just wouldn't need to use the rx-out jack.
Am I am missing something here?