[Elecraft] XG3_Signal_Source

[Bruce Beford]

I don't think the CS2100 fractional-n synthesizer used in the XG3 will allow
operation as low as you are asking. Perhaps Bob (the designer) will chime in
on this. OTOH, you could always build your own divider, and use the XG3 at a
freq that it can produce now. If you are designing transverters for 630M,
this should be a trivial task.

GL,
Bruce 
N1RX

> I would like to request a change in the firmware that would allow me
> to Edit the frequency of the 160M band to 475 khz.