[Elecraft] K3 Setup Failing

[Brian F. Wruble]

That control acts normally.  I can set the power from 0 to 100+ watts, and
the green light is on.  After the calibration run, power = 0.0.briefly
flashes up, and then it goes to where I had the power set before the run
--- 5.0 watts in my case.



*Brian F. Wruble, C.F.A.

*70 is the new 40.*
*
Mail: 1107 Key Plaza, PMB 447 Key West, FL 33040-4077
Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD 21930
eFax  305.768.0278







On Sat, May 25, 2013 at 9:59 PM, Ed <edwest at sisqtel.net> wrote:

> Brian
>
> What does the display show when you manipulate the power control knob.
> It must have the green LED lit indicating “PWR” above the knob.  If I
> remember correctly the calibration process will set the output to “0” after
> calibration.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>