[Elecraft] K144XV Strange Readings

[Chad Wasinger]

Mike - yes, I've seen the same thing. I can't put my finger on it either but when using the k144xv with my wattmeter, I have high SWR always. Normally I can still run the 5-7 watts into an amp without issues but there are times this high SWR trips things off.
Elecraft - it would be nice to finally understand what needs to be done to correct this issues. Very common among the users that are on SSB/CW, not so much FM. 

> Date: Fri, 17 May 2013 05:26:24 -0500
> From: mteberle at mchsi.com
> To: Elecraft at mailman.qth.net
> Subject: [Elecraft] K144XV Strange Readings
> 
> I've noticed strange behavior on both the W2 watt meter and a 
> cross-needle meter when using my K3 on 2 meters.  Just curious if anyone 
> has had problems like this?  In SSB mode, keying the mic without any 
> audio causes the watt meter to show about 3 watts output power and 3:1 
> SWR.  However If I hold the TUNE button and put out a carrier It shows 
> the expected 7-10 Watts forward with normal low SWR.  It also appears to 
> show normal readings while speaking into the mic, but goes to the 
> unusual readings with in between audio peaks.
> 
> Thanks
> Mike KI0HA
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html