[Elecraft] KX1 absolute Vmax ??

[Philip Townsend Lontz]

The user book says 14vdc... I have a reg. power supply that does,15.000 vdc. Is that going to be a problem?
Phil

Non judgement day is near




On May 10, 2013, at 7:02 PM, Mike Weir <ve3wdm at hotmail.com> wrote:

> Good evening all, just making my way through the K2 build and had was wondering about some resistance check results. On R115 and U1 pins 4,9,10,28 I am getting readings in the range of 3.9 mega ohms to 5.4 mega ohms. The results sheet advise of results in and around 20k. In the past I have found that the measured amount was somewhat close to the expected manual. To me it just seems a bit high when you are to see greater than 20K and the measured amount is in the Mega ohms....is this normal?The last measurement question I have is for R1 and R2. I have to see 1mega ohm or more and my Fluke is just reading OL....is this what I am looking for?The only "normal" reading in this check out to me is U1 pin 1 which comes in at 4.85K Thanks for your timeMikehttp://elecraftk2.blogspot.ca/
> 
> Exact readings I am gettingR115          9.57mega ohmsU1Pin 4           3.9 mega ohmsPin 9            4.8 "                 "Pin 10          4.7 "                 "Pin 28           5.4 "                " 
> 
>                         
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html