[Elecraft] Resistance checks on RF board page 38

[Mike Weir]

Good evening all, just making my way through the K2 build and had was wondering about some resistance check results. On R115 and U1 pins 4,9,10,28 I am getting readings in the range of 3.9 mega ohms to 5.4 mega ohms. The results sheet advise of results in and around 20k. In the past I have found that the measured amount was somewhat close to the expected manual. To me it just seems a bit high when you are to see greater than 20K and the measured amount is in the Mega ohms....is this normal?The last measurement question I have is for R1 and R2. I have to see 1mega ohm or more and my Fluke is just reading OL....is this what I am looking for?The only "normal" reading in this check out to me is U1 pin 1 which comes in at 4.85K Thanks for your timeMikehttp://elecraftk2.blogspot.ca/

Exact readings I am gettingR115          9.57mega ohmsU1Pin 4           3.9 mega ohmsPin 9            4.8 "                 "Pin 10          4.7 "                 "Pin 28           5.4 "                "