[Elecraft] GPD 10 MHZ Reference

Matthew Zilmer mzilmer at magellangps.com
Tue May 7 17:19:48 EDT 2013


Make sure the HP's output signal level is about right (~12.5 dBm, I think...) before using it.  If it's a square wave output at 5V/0V, you're supposed to add a series resistor.  I think this is all in the K3EXREF manual.

73,
Matt W6NIA


-----Original Message-----
From: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of W4CCS
Sent: Tuesday, May 07, 2013 2:05 PM
To: 'Matt Zilmer'
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] GPD 10 MHZ Reference

Thanks to all who replied.. I just had a friend of mine give me an HP 58503A. Think I'm going to give it a try..

W4CCS 

>What are you using as a 10 MHz source for the K3EXREF..??
>
> 
>
>Clyde scott - W4CCS
>
> 
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net Please help support this email
>list: http://www.qsl.net/donate.html


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html


More information about the Elecraft mailing list