[Elecraft] K2 Part 2 and alignment

Don Wilhelm w3fpr at embarqmail.com
Mon Mar 25 09:22:44 EDT 2013


Christophe,

The voltage that you see in the display will always be lower than the 
voltage at the input power jack.
There is a reverse polarity protection diode in the K2 and there is a 
slight voltage drop across the fuse.
That will make the voltage inside the K2 0.4 to 0.5 volts lower than the 
voltage of your power source.

73,
Don W3FPR

On 3/25/2013 8:28 AM, Christophe F8ACF-56 wrote:
> hello all,
>
> Part 2 and alignment validated everything is OK, BFO = 5.9 kHz, VCO of 2.17 V to 6.0 V, 13 KHz PLL so it's OK
>
> Song minor or I do not see how pressing the button "display" was the voltage and amperage, the amperage is only Ok, there is a gap between the multimeter reading and that of K2, I not know the origin or the setting of this part
>
> for those that want to place or is the video test::
>
> http://dl.free.fr/tS9ocrCFC
>
> thank you for your help
>
>



More information about the Elecraft mailing list