[Elecraft] [K2-KPA100] Hi Refl

[Dana Phillips]

I have installed the 100w amp in my K2 and am in the final calibration 
stage but I have encountered a problem.  When switching in the amp 
stage, I get a "Hi Refl" message. This is problematic because I am 
transmitting into a  50 ohm commercial dummy load, and I have tried 3 
different coax jumpers with no effect.

Is there a setting for the SWR sensor that I am missing?  Is there a 
component or connection that I should check?

Thanks in advance
Dana N6DW