[Elecraft] Kenwood Mc-60 mic with K2

[Mike Flowers]

My MC-60 mic says on the bottom by the switch 'mic amp' in/out.   There
isn't an 'A' on the Kenwood trim on the front - just MC-60.   Although it
may be an MC-60A, there is no visible designation as such.

- 73 de Mike, K6MKF, W6NAG, NCDXC, Conway Reef 2012, K3-P3 Addict, Maui

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wilhelm
Sent: Thursday, March 14, 2013 4:12 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Kenwood Mc-60 mic with K2

The MC-60 (not A) schematic that I see on the G4WPW website indicates that
the switch changes from low impedance to high impedance.  For use with the
K3 and other modern transceivers the switch should be in the low impedance
position.
 From the schematic, I cannot understand an "out" label on the switch.  
If you have an MC-60A, then "out" would be reasonable referring to the
preamp either in or out.

73,
Don W3FPR

On 3/14/2013 6:53 PM, Stephen Roberts wrote:
> It's a MC-60 and the switch is "Out".
>
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html