[Elecraft] KPA500 Fan Power Connection Issue

[AG0N-3055]

On Tue, 12 Mar 2013 13:51:46 -0700 (PDT), Bill Wiehe wrote:

> I believe the issue you describe is the same one I am in the process of correcting in that the power connection for the fan would not seat properly. I called Elecraft and spoke with a tech and we determined that the pins had an over run of solder down into the channel blocking full seating of the connector around the pins.

If I had been able to force the pins into the connector enough to go
flush the way it should have been, the pins would have been sticking out
of the connector along side the wires at the top!  :o)

Gary
-- 
http://ag0n.net
3055: http://ag0n.net/irlp/3055
NodeOp Help Page: http://ag0n.net/irlp