[Elecraft] Trouble with Auto-Spot (K3)

[Mike Flowers]

I have seen this behavior as well, but only when the signal was very low
level.   The vast majority of CW signals 'Spot' just fine for me.   I'm
running the latest production firmware.

- 73 de Mike, K6MKF, W6NAG, NCDXC, Conway Reef 2012, K3-P3 Addict, Maui


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of paul ecker
Sent: Tuesday, March 12, 2013 7:15 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Trouble with Auto-Spot (K3)

Have recently noticed that the Auto-Spot feature on my K3 is not working as
well as it used to. With CWT on, if I manually tune the signal, to get a
blinking bar to show in the CW/Data Tuning Aid area of the S-Meter area, and
then Tap SPOT, it drives the signal off the tuning bar, whereas it used to
bring it to the center and zero beat it. I am using filter settings between
200-400. I have THR set at 2. Any ideas on what I can do to correct this?

73 Paul kc2nyu
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html