[Elecraft] KPA500 Fan Power Connector issue

[k2np]

Hi Mark,

 I had the exact same issue. It looks like pins in the manual are probably
shorter than they are in the latest kits.  I put it on 2/3rds of the way and
it seemed to 'latch' in place. I finished assembling the kit and the fan was
working so I figured that was good enough.

Cheers,
Travis K2NP
ZL3AB wrote
> Hi
> 
> The [fan] connector stops about two thirds of the way down the pins.  It
> seems there is something in the connector itself stopping them going any
> further as the connector socket not used goes all the way down easily.
> 
> The picture in the assembly manual suggests the connector should go all
> the way to the bottom so if anyone has any suggestions I would appeciate
> it.
> 
> 73
> Mark ZL3AB





--
View this message in context: http://elecraft.365791.n2.nabble.com/KPA500-Fan-Power-Connector-issue-tp7570653p7571160.html
Sent from the Elecraft mailing list archive at Nabble.com.