[Elecraft] General coverage bandpa

[Edward R Cole]

Harlan,

I chose the main receiver since I assumed most casual listening 
outside the ham bands would not involve both Rx.  Also, I use the 
main receiver on the 500-KHz band for operating with an experimental 
license.  The general coverage board is required to operate out of a 
ham band in TEST mode.  That is how I transmit on the 600 meter band; 
taking 1mw level RF to drive a modified surplus NDB transmitter (the 
K3 replaces the original xtal osc.).

But I guess it would reduce to a personal decision for deciding which 
receiver to install it in.

73, Ed - KL7UW

From: Harlan <hsherriff at reagan.com>
To: Elecraft Email <elecraft at mailman.qth.net>
Subject: [Elecraft] General coverage bandpass module
Message-ID: <ryi94mxyxvb12xk8ndr13xd9.1362970670106 at email.android.com>
Content-Type: text/plain; charset=utf-8

For those with the sub receiver and only one bandpass module...

Which receiver is it assigned to and why did you pick that receiver?

Harlan
NC3C