[Elecraft] [K2] Power supply for KAT100-1

[Don Wilhelm]

One safety thing I should point out is that a power supply will 
typically fold back if the current is greater than the current rating of 
the supply, but all power cables that are of a smaller gauge than the 
current handling capability of the supply should be fused at the power 
supply end with a fuse.  The fuse current rating should be matched to 
the wire gauge.
If you do not know the current handling of a particular wire gauge, 
consult a copper wire table.

Be safe.

73,
Don W3FPR
On 3/9/2013 8:41 AM, K1FFX wrote:
> Mike and Don -
>
> Thanks for your replies.   I use either an Astron 20 or the MFJ-4125 (about
> 22 amp
> switching supply) with the K2/100, usually running at the 100 watt output
> level.
> Sure would be great if one or both supplies would be adequate for running
> both the rig
> and the KAT100.  Your thoughts?
>