[Elecraft] RC2 - high side and low side different

[Cady, Fred]

Thanks Don. With diodes that will work great.
73
Fred


-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at embarqmail.com]
Sent: Fri 3/8/2013 11:08 AM
To: Cady, Fred
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] RC2 - high side and low side different
 
Fred,

You can wire "OR" either the high side or the low side.
If you are running the tribander on the low side, just connect the 10, 
15, and 20 outputs together, and drive the bandpass filter from the 
separated low side outputs.  Swap 'high' and 'low' if required.

73,
Don W3FPR

On 3/8/2013 12:56 PM, Cady, Fred wrote:
> Thanks Jack. I figured that was the case. What I want(ed) to do is drive
> the 6-pack x-bar switch which has a tribander on it so 10-15-20 will be
> mapped to the same output PLUS drive a 6-band bandpass filter which
> needs to have separate outputs for 10-15-20. Any ideas?
> Cheers,
>