[Elecraft] RC2 - high side and low side different

[Cady, Fred]

Thanks Jack. I figured that was the case. What I want(ed) to do is drive
the 6-pack x-bar switch which has a tribander on it so 10-15-20 will be
mapped to the same output PLUS drive a 6-band bandpass filter which
needs to have separate outputs for 10-15-20. Any ideas?
Cheers,
Fred KE7X 

-----Original Message-----
From: Jack Brindle [mailto:jackbrindle at me.com] 
Sent: Friday, March 08, 2013 9:44 AM
To: Cady, Fred
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] RC2 - high side and low side different

Fred;

If you mean the KRC2, the high and low side drivers are locked together
in hardware, so no they cannot be separated. With 16 configurable
selections, it meets most folks needs.

This is also a good time to remind folks that the final KRC2
configuration tool is on the Elecraft web site. The text may say "beta",
but it is the real thing.

Jack Brindle, W6FB

Sent from my iPad

On Mar 8, 2013, at 7:17 AM, "Cady, Fred" <fcady at ece.montana.edu> wrote:

> Can the RC2 controller be set up so the high side driver configuration

> is different than the low side?
> 
> Thanks and cheers,
> Fred KE7X
> 
> Fred Cady
> fcady at ieee dot org
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net Please help support this email

> list: http://www.qsl.net/donate.html