[Elecraft] KPA500 Serial Port Problem

[Dick Dievendorff]

Sometimes people select the wrong serial port # in the KPA Utility.  If you
have several ports to choose from on the "Ports" tab, try each.

73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of David Mitchell
Sent: Friday, March 08, 2013 4:49 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] KPA500 Serial Port Problem

I  bought an KPA 500 this fall and just started using it because my antenna
was down from the hurricaine.  I can't get the serial port to communicate
with my computer.  I bought two of the UISB to serial cables with the FTDI
chipset, which I KNOW work because my Winkeyer uses one, and neither one
could find my amp.  I then bought a two port PCI serial card and a
conventiional cable and could not connect using that setup, even though
Windows XP says that all the ports are working properly.

Any suggestions are appreciated.  I might just have a bad serial board and
the amp should still be under warranty.

--
Dave WB2PJH
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html