[Elecraft] K2 Transverter set up query

[Don Wilhelm]

Vic,

To get the frequency to display correctly, do a Direct Frequency Entry 
for the 0000 band and that should straighten things up for you.  Hold 
both BAND+/- buttons and enter 00000 and all should be well.

As for it not working on TRN2, the K2 does not care which transverter 
band is selected - The K2 does the same thing.  When the power is set to 
the L range, it will receive a 28 MHz signal on the transverter IN 
jack.  Try connecting a 28 MHz signal source to the IN jack and see if 
you have signals.  Make certain you did not bump the VFO knob when 
exiting the transverter menu - that could place your power setting to 
the high range which would switch receive (and transmit) to the BNC jack.
The only difference between TRN1 and TRN2 is the address sent to the 
transverter over the AUXBUS signal line.

73,
Don W3FPR

On 6/30/2013 10:12 AM, Vic wrote:
> Hi All,
>
> I have a K2 with K60XV module, and I have an XV50 transverter set up as TRN1
> all working fine and K2 is showing correct frequency when using the KV50.
> The TRN settings are :
> RF                   50
> IF                     28
> OFS                0
> Power out       L1.00
> Adr                  TRN1
>
> Now, I want to add a VLF receive converter  (this provides 0-150khz
> coverage) as TRN2
>
> I have set this up as:
> RF                   0
> IF                     28
> OFS                0
> Power out       L0.01
> Adr                  TRN2
>
> I temporarily have the XV50 disconnected  entirely and the VLF converter
> connected to the transverter IN phono socket on my K2.
>
> I have two issues:
>
> 1  The VLF converter is working on TRN1 although the frequency naturally
> shows 50000 to 50150Khz  but it does NOT work on TRN2. No received signals
> at all.
>
> 2        On TRN2 the frequency readout shows a frequency of around 86Mhz -
> 87Mhz and no signals from the VLF converter.
>
> Can anyone suggest what I'm doing wrong here please. I'm wondering if I need
> to connect the VLF converter via the XV50 which to enable the switching to
> work correctly somehow.
>
> I'd be most grateful for any suggestions.
>   
> Please  copy any replies to my e mail address.
>
> 73,
>
> Vic GW4JUN
>