[Elecraft] OK, KX1 nervous Nellie question testing the 80-30 board

[Peter N. Spotts]

Hi Folks,

I've just installed the 80-30 board (filter left to go), and in making 
the final current and voltage checks, I was unsure if one reading was 
too high. If the current draw after the LED times out is between 34 and 
37 ma, good. If it's much higher than that, it could indicate a short. 
How much higher?

I got a reading of about 38.9 ma. The various voltage checks all were 
fine, between 4.8 and 5 vdc. So I presume those are OK. It's the current 
measurement that I'm a bit concerned about.

Any thoughts, other than I need to chill?  ;-)

With best regards,

Pete

-- 
Peter N. Spotts -- W1PNS
http://www.w1pns.net
Email: w1pns at arrl.net | Skype: pspotts
QCWA #34679 | SKCC #4853T | QRP-ARCI #4174
NEQRP #714 | NAQCC #2446 | GQRP #13202

"Amateur radio is a contact sport.
Get on the air and make a contact!"
        -- Lyle Amundson, K0LFV