[Elecraft] Anderson Connector

[G8DX]

Thanks for all replies both on and off list.

I will take a look tomorrow and see if I
can improve it.

--
73 de G8DX/A

On 24 Jun 2013, at 13:42, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> Jack,
> 
> The most common cause for that condition is that the connector blades have not been inserted into the APP body far enough.
> Look at the end of the connector assembly - if you can see the tip of the spring finger under the contact blade, then the blade has not been fully seated - give it a push with a small screwdriver and it should snap into place.
> 
> A properly constructed APP connector takes about 10 pounds of force to remove it.
> 
> 73,
> Don W3FPR
> 
> On 6/24/2013 8:26 AM, G8DX wrote:
>> Hi
>> 
>> Just finished building the basic K3 (sub rx and 100w PA awaiting installation).
>> 
>> Total build time was about 10 leisurely hours spread over a week. Throughout the entire build I have only found one small issue which I find remarkable! Hats off to Elecraft.
>> 
>> Anyway, my issue is the Anderson power connector doesn't firmly latch onto the connector on the rig. It fits on and powers the rig but pulls off very easily. Have I installed it incorrectly maybe?
>