[Elecraft] P3 Sensor port

[Jack Berry]

Gary, anything shared with you?

On Jun 10, 2013, at 1:44 PM, Gary Gregory <vk1zzgary at gmail.com> wrote:

> I understand the sensor port is for an inline sensor to allow the P3 to
> monitor the TX signal from the K3. A long time waiting for the release of
> this has not dampened my enthusiasm but the lack of information on timing
> of the release is disappointing.
> 
> I think i read it is on 'someones' list but that is all I have read.
> 
> Perhaps somebody "in the know" will chime in here?
> 
> 73
> 
> Gary
> 
> On 10 June 2013 00:43, Rob Gault <kc2vmp at gmail.com> wrote:
> 
>> Anything in development to fill the sensor port hole on the P3?
>> 
>> 73
>> kc2vmp
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> 
> 
> 
> -- 
> *Gary - VK1ZZ
> Skype: Gary.VK1ZZ
> Motorhome Portable
> The Shack*
> *Elecraft K3
> P3 Panadapter
> KPA500FT
> KAT500FT**
> KX3-K
> *
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html