[Elecraft] KX3 firmware rev. 1.51 with CW-in-SSB feature (attached)

[Jim Sheldon]

Hi Wayne & all,
After actually playing with the feature, the easiest solution to changing speeds might be to explain it in the release notes.  All you really have to do is briefly change mode to CW, set the speed and change back to SSB.  CW in SSB stays active and it only takes a couple seconds to do this.  

The FW revision now shows 1.51 in the menu - LOL - hopefully that's the only real bug we find in it.

Jim - W0EB

> Hi Rick,
>
> I confirmed the problem with KEY1 = HAND. I'll look into this.
>
> As for adjusting speed: this is a little problematic because, as
> you observed, the knob has a different function in SSB mode. I'll
> have to think about whether there's a way to allow keyer speed
> control without causing confusion with the RF/ALC selection
> function.
>
> Wayne
>
> On Jun 11, 2013, at 8:58 AM, Rick Tavan N6XI <rtavan at gmail.com>
> wrote:
>