[Elecraft] KX3 and 2 Meters

[Rich Heineck]

Hello Steve,

It sounds like the menu is set up for a 2m transverter.  Go into the 
menu and find XV1 ON, and make sure the selection is 'no' (before making 
a change, you have to unlock it by holding RATE down for a few 
seconds).  Hope this helps.

73,
Rich AC7MA


On 06/10/2013 01:08 PM, Steve wrote:
> I am the new owner of a slightly used (only on Sundays that didn't conflict
> with baseball or football, according to the previous owner) KX3 and just
> beginning to understand how it works.  I am slowly reading each page of the
> operator's manual and checking each function of each knob and button so I
> can make contacts without messing up everything.  I notice that 60 meter
> frequencies are not programmed and I will have to do that.
>
> One question I have, the answer to which I can't find anywhere in the
> operator's manual, is why 144.000 (fully tunable to 148.000) comes up after
> 6 meters if the module to do this has not been produced.  Is this just
> there as a default and actually is an inoperative band for later use or
> ..... what??
>
> Just wondering why this is not mentioned anywhere nor have I seen this
> question on the reflector (of course, with the tons of e-mails, I may have
> missed it.
>
> Tnx & 73,
>
> Steve, N4EUK
> K2/100, KX3
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>