[Elecraft] P3 settings issue

[Alan Bloom]

You can do a "Parameter Initialization" as described in the 
Troubleshooting section of the manual.  Basically, you hold the LABELS 
key while turning on the P3 with the POWER switch.  Wait until the 
"CONFIGURATION RESET" message appears on the screen and release then 
release the LABELS key.  If you have the power-on jumper in the P3 
configured to always-on, then just hold LABELS and tap POWER.

Alan N1AL


On 6/8/2013 8:07 PM, Gary Gregory wrote:
> Things have been going well until 'Fat Fingers' decided to press buttons.
>
> Is there an easy way to set the P3 to default settings other than sing the
> utility?
>
> Busy in a contest and would like to not have to disconnect the logging from
> the K3 to fire up the utility.
>
> 73
>
> Gary
>