[Elecraft] KX3: I/Q out on TRANSMIT?

[Ariel Jacala]

Brian

At least in my setup using NaP3. The TX signal is visible on the panadaper display with no extra cables

Ariel

Sent from my iPhone

On Jun 8, 2013, at 10:30 AM, "Rich Heineck" <richei at frontier.com> wrote:

> Brian,
> 
> The TX I/Q signals are only routed internally and aren't at any external connector, though they do have labeled test points.  The I/Q connector on the side is an RX output only.
> 
> 73,
> Rich  AC7MA
> 
> 
> On 06/08/2013 04:49 AM, Brian Machesney wrote:
>> I would like access to the I/Q signals produced by the DSP modulator on
>> transmit. Are these signals available on the rig's I/Q outputs?
>> 
>> Brian K1LI
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html