[Elecraft] A Rob Sherwood's talk in Dayton

[Phil Hystad]

If I were using external amplified speakers (which I am not right now) on my K3, would I use the rear panel SPKR stereo plug, or the headphones connector stereo plug, or the stereo line out plug?  Or does it matter?  Noted that the line out impedance is much different than SPKRS or PHONES.

73, phil, K7PEH


On Jun 7, 2013, at 8:18 AM, Wayne Burdick <n6kr at elecraft.com> wrote:

> Rob helped us identify the K3's audio output distortion issue, which we subsequently cleaned up with a hardware change (five years ago) and new firmware (about three years ago). 
> 
> If you have an older K3, see:
> 
>   http://www.elecraft.com/K3/mods/K3_AF_Stage_Upgrade_Instructions_Rev_B.pdf
> 
> This mod, long since incorporated into production, adds a large RF choke in series with the AF amplifier stage's DC supply. As Rob's plots show, this dramatically knocked down the IMD products; most are now down 70-80 dB. I have pretty good ears, and once we made this change, I couldn't hear any difference between the internal amplifier and external powered speakers.
> 
> Rob is correct that it would be possible to further reduce low-level distortion products. However, many of these fall outside the hearing range of the average user because they're related to an image of the 12-kHz CODEC sampling rate. What's left within hearing range could be reduced with a change in the AF amp IC, though there are diminishing returns and pragmatic considerations. The stereo audio amplifier IC we use is capable of driving two 4-ohm speakers at up to a few watts apiece, and it generates no RFI because it is a classic analog device running class AB. We could get higher drive power using a beefier analog device with much higher quiescent current, or by using a class-D or higher switching-style device. The former would increase the radio's current drain substantially, while the latter would require additional shielding and decoupling. 
> 
> As always, our goal is to continuously improve the K3 in a way that is applicable to units in the field. If we find a practical way to achieve a further significant improvement in the audio channel, we'll certainly make it available. 
> 
> 73,
> Wayne
> N6KR
> 
> 
> On Jun 7, 2013, at 3:55 AM, Bill W4ZV <btippett at alum.mit.edu> wrote:
> 
>> Hisashi T Fujinaka wrote
>>> Can anyone point out more about the K3 transmit audio fixes that
>>> Sherwood talked about?
>> 
>> I thought most of the comments were about receive audio distortion.  There
>> have been several changes, both hardware (DSP upgrade) and firmware (AGC
>> Decay) and possibly others which affect this.
>> 
>> 73,  Bill  W4ZV
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html