[Elecraft] K3 Frequency Memory Editor

[ANDY NEHAN]

Hi, I have noted that when I use the above utility it does what I want apart from the 50MHz band. I set it to the required frequency and mode (50.250 and Data) yet when I upload that info to the K3 the mode becomes Data Rev. This does NOT happen on any other band (and I use the memories to get me to the PSK frequencies for all bands). On the other bands the frequency is correct and the mode is Data.

I have tried changing the mode on the K3  to Data then reading that into the K3 Frequency Memory Editor and then re-exporting it back to the K3 - but the result is the same.

I guess it must be obvious what I am doing wrong but it sure is puzzling me at the moment!!

Andy
G4HUE
K3 s/n 6990
P3 s/n 2493