[Elecraft] KX3 Beta firmware rev 1.54: CW transmit in SSB mode (etc.)

[Ralf Wilhelm]

Hi Richard,

If it really is 12 V, the voltage might be too low. I don't have the manual for the charger at hand in the moment, but I think it says it would like to see 13.8(?) V or something very close to this.

Vy 73

Ralf, DL6OAP



Am 31.07.2013 um 14:37 schrieb Richard Neese <kb3vgw at gmail.com>:

> is there a way to add a option under the firmware to show what the current batt charge status is ?
> so you know if you need to charge or not.
> 
> also I have a 12v 4.58 amp power supply I am using and I get a lower supply warning when I try to
> charge the batt with  the radio in standby mode ....
> 
> should 4.58 amp 12v not be enough to charge ? I use the supply to run the radio and get no issue
> sexecpt when I put it in batt charge mode...
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html