[Elecraft] K1 problem solved

[Mike Morrow]

David wrote:

> ...I discovered that by tightening down the front panel screw
> (under the tuning knob) I had pulled the FP printed circuit
> board away from the panel, and that meant the P1 and J1
> connectors weren't parallel.

That does not seem normal at all.  My K1 front panel does not
flex as the flat-head front panel mounting screw is tightened,
however much I try.

Are you sure that the front panel stand-off (to which the flat-head
screw will attach) was mounted to the front panel PCB with *two* #4
lock-washers below it, as described and illustrated on page 20 of
the K1 manual?

Mike / KK5F