[Elecraft] Bright line in bar cursors

[WX2S]

Stan,

That was exactly it. REF CAL was way off, about 63 counts. Calibrated against WWV and it's fine now.

Thanks and 73,
- Steve WX2S.





________________________________
 From: "Stan Gibbs, KR7C [via Elecraft]" <ml-node+s365791n7576762h92 at n2.nabble.com>
To: WX2S <steve.masticola at verizon.net> 
Sent: Monday, July 15, 2013 5:24 PM
Subject: Re: Bright line in bar cursors
 


Tuning the radio such that the bright cursor bar (VFO frequency) is aligned with the received signal should give you exactly the pitch that you set unless your P3's REF CAL menu setting is incorrect. 


WX2S wrote
>I would like to set up the bright line in the bar cursors in CW mode so that it indicates not the VFO frequency, but the proper place to tune for the correct sidetone pitch. Is there a way to do this? 
73, Stan - KR7C 

________________________________
 
If you reply to this email, your message will be added to the discussion below:http://elecraft.365791.n2.nabble.com/Bright-line-in-bar-cursors-tp7576736p7576762.html 
To unsubscribe from Bright line in bar cursors, click here.
NAML 



--
View this message in context: http://elecraft.365791.n2.nabble.com/Bright-line-in-bar-cursors-tp7576736p7576767.html
Sent from the Elecraft mailing list archive at Nabble.com.