[Elecraft] [K2] N1MM Logger with KPA100

[Don Wilhelm]

Bruce,

Given that information, you may have been able to correct it by altering 
the port 'handshaking' settings in your computer.
But you have fixed it, so go with it.
I did not know that the handshaking loopback would cause a failure, 
thanks for that information.

73,
Don W3FPR

On 7/13/2013 9:43 PM, K1FFX wrote:
> Thanks, Don.  I went and tried it with my previous PC and it worked fine.
> So, I went back to the
> KPA100 manual to look at how the pinouts were specified.  The manual
> recommended looping CTS to
> RTS on the PC side, which I did when I first built the KPA100 and it worked
> fine with the PC that was current at that time.  But not with new PC!  I
> pulled the jumper out and it now works fine with N1MM logger on the new PC.
>
> So, KPA100 serial cable builders ... keep an eye out for this one ... that
> jumper may disable K2 to PC communications.
>
> Thanks again, Don.
>
> - Bruce K1FFX
>